bsps: Move documentation, etc. files to bsps

This patch is a part of the BSP source reorganization.

Update #3285.

bsps/arm/lpc24xx/README

@@ -0,0 +1,52 @@
+Development Board: QVGA Base Board from Embedded Artists
+
+http://www.embeddedartists.com/products/uclinux/oem_lpc2478.php
+
+Drivers:
+
+	o Console
+	o Clock
+	o RTC
+	o SSP (SPI mode)
+	o Network
+	o I2C
+
+Howto setup QVGA Base Board?
+
+	o Unpack board.
+	o Connect board via USB to your PC.
+	o Verify that demo application runs.
+	o Disconnect board.
+	o Change jumpers to enable ISP.
+	o Connect board.
+	o Load U-Boot image 'u-boot_v1.1.6_lpc2468oem_v1_8_16bit.hex'
+	(available from the EA support page) into the flash (flash tool
+	FlashMagic is availabe from NXP).
+	o Change jumbers back to disable ISP.
+	o Use a terminal program to change the U-Boot settings via the console.
+	o U-Boot settings:
+		set ethaddr '00:1a:f1:X:X:X'
+		set serverip 'X.X.X.X'
+		set ipaddr 'X.X.X.X'
+		set rtems 'tftp a1000000 lpc2478.img;bootm'
+		set bootcmd 'echo Booting RTEMS ...;run rtems'
+		saveenv
+
+Howto make a U-Boot image?
+
+mkimage -A arm -O rtems -T kernel -C gzip \
+   -a a0000000 -e a0000040 -n "RTEMS Application" -d app.bin.gz app.img
+
+Application Board: NCS (Nurse Control Station)
+
+	Board:      NextGenNCS
+	Processor:  NXP LPC2478 or LPC2470
+	SDRAM:      8MByte, 16 bit wide
+	Ext. Flash: 1MByte, 16 bit wide
+	Console:    UART, 115200 Baud
+	Network:    100Base-T
+
+Application Board: TLI800
+	TLI800 is a network node using four serial ports produced by Thorn
+	Security Limited.  It is used by Tyco Fire & Integrated Solutions for a
+	fire control network.